Wolverine Stack Dosage Chart: Daily and Weekly Doses

The Wolverine Stack Dosage Chart

First, the naming problem. "Wolverine stack" is not a drug, a brand, or a regulated product. It is the nickname forums attached to running BPC-157 Explore PeRxBPC-157The Body Protection CompoundView peptide and TB-500 together, and because the name has no owner, it has no official dose. What the stack is and where the name came from is covered in the Wolverine stack peptides guide Read nextWolverine Stack: BPC-157 and TB-500, ExplainedThe wolverine stack is two peptides, BPC-157 and TB-500, run together for injury recovery. This guide covers where the comic-book name came from, what each peptide contributes, what the research honestly supports, the side effects and open questions, what forum reports get right and wrong, and how the prescribed single-vial version differs from buying two research vials.Read article ; how it differs from the GLOW and KLOW blends is decoded in GLOW vs KLOW vs Wolverine stack Read nextGLOW vs KLOW vs Wolverine Stack: Which One?Three nicknames, four peptides, one recurring confusion. GLOW is GHK-Cu plus BPC-157 plus TB-500. KLOW is GLOW with KPV added. The Wolverine stack is BPC-157 and TB-500 on their own. Here is what each name actually contains, which goal each one fits, what a prescribing clinic dispenses in their place, and why an $80 research vial and a $349 pharmacy vial are not the same product.Read article . This page is only about the numbers.

The chart below shows the stack as it is actually prescribed through PeRx: both peptides compounded into one vial at 3 mg of each per mL, dosed at 20 units on a U-100 insulin syringe. Every row follows from those two facts.

That is the whole chart, and its shortness is the point. One concentration, one draw, one schedule. If you want the deeper arithmetic behind these rows, vial contents, doses per vial, unit-to-milligram conversions at every syringe marking, cost per injection, all of the full units math lives in the BPC-157/TB-500 dosage chart Read nextBPC-157/TB-500 Dosage Chart: Units, mg, CycleThe prescribed BPC-157/TB-500 blend has one concentration and one dose, and every number on this page follows from those two facts. Draw 20 units and you get 0.6 mg of each peptide. Here is the full arithmetic: the dosage chart, units on an insulin syringe, per-day and per-week totals, how the capsules dose differently, and what a month actually costs.Read article . This page stays focused on what people searching for the Wolverine stack actually ask: how the forum numbers map onto the prescribed ones.

Forum Protocols vs the Prescribed Version

Most Wolverine stack charts circulating online assume two separate gray-market vials, because that is how the research-chemical market sells the peptides. The protocol shape that repeats across forums looks roughly like this: BPC-157 at 250 to 500 mcg injected once or twice daily, and TB-500 at 2 to 2.5 mg once or twice a week, often front-loaded for the first four to six weeks in what forums call a loading phase, then dropped to a smaller maintenance shot every week or two. Cycle lengths of four to eight weeks are typical.

To be clear about what those numbers are: community conventions built for unregulated products, not doses derived from human trials. Neither peptide has published human dose-finding data, so no forum chart can claim a clinical basis; this page describes those protocols so you can translate them, not run them. They also carry a hidden variable. A research-chemical powder has whatever concentration the buyer creates when they add water to the vial, so two people following the same chart can be injecting meaningfully different amounts.

Read across the weekly row and the two versions land closer than the schedules suggest. A mid-range forum protocol delivers 2 to 3.5 mg of BPC-157 and 2 to 5 mg of TB-500 per week; the prescribed blend delivers 3 mg of each. The real difference is rhythm. Separate vials let forums schedule TB-500 as a big infrequent shot while BPC-157 runs daily. A 1:1 blend cannot split the schedule, so both peptides arrive in smaller daily amounts on the same weekday clock. The reasoning behind putting them in one vial in the first place is laid out in why we pair BPC-157 and TB-500 Read nextWhy We Pair BPC-157 With TB-500BPC-157 and TB-500 are both repair peptides, but they cover different ground. BPC-157 works fast and focal, strongest at a specific injury and in the gut. TB-500 works broad and systemic, moving repair cells across the whole body. The pairing is not automatic. Here is how a provider decides whether you need both, or whether BPC-157 on its own does the job.Read article .

BPC/TB-500

The prescribed form of the Wolverine stack at PeRx is a single 5 mL vial carrying both peptides at 3 mg per mL each, prescribed by a licensed provider and compounded at a US-based 503A pharmacy. It ships fully reconstituted and ready to use, refrigerated, with insulin syringes in the box.

No mixing, no concentration math, no separate TB-500 schedule to manage. One 20-unit draw delivers both peptides in a fixed 1:1 ratio. $299 for the monthly vial, with an oral capsule version at $225 if needles are a dealbreaker.

The Wolverine pair, prescribed as one vial.

Shop Now

Daily Dosage: What Per-Day Actually Means

Searches for Wolverine stack daily dosage stumble over a units mismatch: forum charts quote BPC-157 in micrograms and TB-500 in milligrams, and the two peptides run on different clocks. On the prescribed blend the per-day answer is one number. Dosing days deliver 0.6 mg of BPC-157 and 0.6 mg of TB-500, which is 1.2 mg of combined peptide. Saturday and Sunday deliver nothing, and that is the schedule working as written, not a missed dose.

Two translation traps are worth flagging. First, when a forum chart says "500 mcg per day", it means BPC-157 alone; the blend's 0.6 mg per dose sits just above that, with the TB-500 riding along in the same draw. Second, per-day figures do not transfer between products. A chart calling for 2.5 mg of TB-500 in one shot is describing a standalone vial at some other concentration; chasing it with the blend would mean drawing more than 80 units and taking 2.5 mg of BPC-157 along for the ride. The only per-day number that applies to your vial is the unit count on its label.

Units on an Insulin Syringe

The prescription is written in units because insulin syringes are marked in units. On a U-100 syringe, 100 units is 1 mL, so each unit is 0.01 mL and the prescribed 20 units is 0.2 mL. That mark sits at different heights on a 0.3, 0.5, or 1 mL barrel but means the same volume on all three, so draw to the printed marking rather than judging fill height by eye. The injection goes under the skin, close to the recovering area, rotating spots. Where to inject BPC-157 Read nextWhere to Inject BPC-157: Sites & TechniqueBPC-157 is a subcutaneous injection. The four standard sites all work, but the questions patients actually ask are whether to inject near the injury, how to rotate, and how to do it without a stinging welt. Here is the practical guide people want after the first vial arrives.Read article maps site selection, and How to Take Peptides Read nextHow to Take Peptides: Injection, Capsule, or StripMost prescription peptides are injected under the skin, a few are swallowed, and a small category dissolves under the tongue. This is the route-of-administration hub: why the route matters, exactly how a subcutaneous injection works, when each peptide is usually taken, what arrives in a PeRx kit, and a directory of per-peptide injection-site guides.Read article walks the full sequence from swab to sharps container. A row-by-row units table at every syringe marking is in the full dosage chart Read nextBPC-157/TB-500 Dosage Chart: Units, mg, CycleThe prescribed BPC-157/TB-500 blend has one concentration and one dose, and every number on this page follows from those two facts. Draw 20 units and you get 0.6 mg of each peptide. Here is the full arithmetic: the dosage chart, units on an insulin syringe, per-day and per-week totals, how the capsules dose differently, and what a month actually costs.Read article .

The Capsule Version

The same peptide pair comes as an oral capsule for people who want the stack without a syringe: 500 mcg of BPC-157 and 500 mcg of TB-500 per capsule, one capsule every morning on an empty stomach with water only, waiting at least 30 minutes before food or coffee. Unlike the injectable, capsules run seven days a week, which puts the nominal weekly intake at 3.5 mg of each peptide against the injectable's 3 mg.

Nominal is the operative word. An injected milligram bypasses digestion; an oral milligram has to survive the gut first, and the two peptides fare very differently there. BPC-157 was isolated from gastric juice and is unusually stable in stomach acid, which is why an oral format exists at all. TB-500 is a larger molecule with poor oral survivability, so the capsule is best understood as a gut-directed BPC-157 product with a partial TB-500 contribution, not a milligram-for-milligram swap for the injection. The trade-offs between routes are laid out in oral vs injectable peptides Read nextOral vs Injectable Peptides: Which Works?Injectable peptides have higher bioavailability. Oral peptides are easier to take. The trade-off is real, and the right choice depends on what you are treating and how much of the peptide needs to reach systemic circulation.Read article . The capsules are $225 for a 30-day bottle.

Cycle Length and Frequency

The prescribed cycle is 6 weeks on, then 6 weeks off, and the prescription says in plain words not to use it continuously. Six weeks at five doses per week is 30 injections and 36 mg of combined peptide. Forum cycles of four to eight weeks orbit the same bounded shape. What the prescribed version adds is that restarting is a provider decision: if there is still a reason to continue after the off period, the next cycle goes back through review instead of rolling over automatically.

The off period is not decoration. BPC-157 has a large preclinical literature, nearly all rodent work, with essentially no controlled human trials behind the doses used in practice. TB-500 is thinner still: the human data that exists belongs to full thymosin beta-4, which reached early-phase wound-healing trials, and the TB-500 fragment itself has no published human dosing data. A bounded cycle caps cumulative exposure while that evidence gap stands. What the pair is used for and what the underlying evidence looks like week by week is covered in the main BPC-157 and TB-500 guide Read nextBPC-157 and TB-500: Dosing and TimelineOne peptide sends the repair signals. The other moves the construction crew into position and builds the blood supply to keep them working. BPC-157 and TB-500 were discovered decades apart, on different continents, for completely different reasons. Practitioners started combining them because the science pointed to an obvious fit: they cover non-overlapping phases of the same healing process. This is the most widely used peptide combination in injury recovery.Read article .

Seiwerth S, Rucman R, Turkovic B, et al. "BPC 157 and Standard Angiogenic Growth Factors. Gastrointestinal Tract Healing, Lessons from Tendon, Ligament, Muscle and Bone Healing." Current Pharmaceutical Design. 2018;24(18):1972-1989. View study

Treadwell T, Kleinman HK, Crockford D, et al. "The regenerative peptide thymosin β4 accelerates the rate of dermal healing in preclinical animal models and in patients." Annals of the New York Academy of Sciences. 2012;1270:37-44. View study

The Dosage Calculator Question

People search for a Wolverine stack dosage calculator because the gray-market version genuinely needs one. When you buy powder and add your own water, the concentration is whatever you made it, and converting a chart's micrograms into syringe units requires arithmetic every single time. The formula, for the record, is simple: milligrams per injection equals units drawn, times 0.01 mL per unit, times the vial's mg-per-mL concentration.

The prescribed blend makes the calculator unnecessary. The pharmacy fixes the concentration at 3 mg of each peptide per mL, so milligrams always equal units times 0.03, and 20 units is 0.6 mg of each, every time. Because the prescription is a fixed 20 units rather than a weight-scaled or titrated dose, there is nothing to compute and nothing to adjust on your own. If a number on some other chart is tempting you toward a bigger draw, that is a conversation for your provider, not a calculation.

Wolverine Stack Dosage: Common Questions